Technical

General Introduction The Alloy 20 bars(UNS N08020) manufactured to ASTM B473 can be furnished in several types: (1)hot-finished rounds, square, octagons, and hexagons: 0.25″(6.35 mm) and over in diameter or size; (2)hot-finished flats: 0.25″~10″, inclusive, in width, 0.125″(3.175 mm) and …

Alloy 20 Pipe & Tube – Relative Standards *All pipes or tubes shall be furnished in stabilize-annealed condition. Chemical & Mechanical Requirements of Alloy 20 Pipe & Tubes The chemical & mechanical requirements of Alloy 20 (UNS N08020) is the …

ASTM B463 Alloy 20 plates, sheets, strips are widely used in the fabrication of pressure vessels, welded pipes or tubes, and other piping components. They can be furnished in various forms which are defined in below table. *The UNS designation …

Metals-Piping has committed experience of manufacturing a variety of ASTM B366 Alloy 20 fittings including 90° & 45° elbows, tees, reducers, 180° bends, caps, crosses, lap-joint stub ends, plugs, bushings, street elbows, , etc. These fittings has the UNS designation of …

General Introduction to Alloy 20 (UNS N08020) Alloy 20, designated as UNS N08020, is an austenitic corrosion-resistant alloy with nominal composition of 35Ni-35Fe-20Cr-Cb. It has the addition of small amount of copper and molybdenum. Alloy 20 was originally developed in 1951 …

ERNiCu-7 is a commonly used filler metal in the welding of Monel 400 piping materials. It is designated as UNS N04060, also known as Monel 60 with nominal composition of 65Ni-30Cu-3Mn-2Ti. The ERNiCu-7 bare welding electrode/ rod can be used in …

Monel 400 flanges manufactured to ASME B16.5 are usually made from two forms of raw material: ASTM B564 UNS N04400 forgings or ASTM B127 UNS N04400 plates. According to the standard, the pressure-temperature ratings can be furnished in two unit …

Monel 400 (UNS N04400) seamless tubes manufactured to ASTM B163 are mainly used for condenser or heat-exchanger service. These tubes are generally furnished in small size with light wall: from 3″ (76.2 mm) and under in outside diameter with minimum wall …

The ASTM B165 (identical to ASME SB-165) is the standard specification covering nickel-copper alloy Monel 400 (UNS N04400) in the form of cold-worked seamless pipe and tube. Metals-Piping supplies Monel 400 seamless pipes sized from 2″ to 16″ covering nominal …

1. Yield Strength – Temperature for Monel 400 Group A *The “Temperature” shall be interpreted as “not exceeding”. *Group A includes Monel 400(UNS N04400) materials:(1)bar of ASME SB164, annealed; (2)seamless pipe & tube of ASME SB165, annealed, with O.D＞5″; (3)ASTM …

1. Tensile Strength – Temperature Table for Monel 400 Group A *The unit of temperature: °F, not exceeding; the unit of tensile strength: ksi. *Group A refers to Monel 400 materials in product form of:(1)bar of ASME SB164, annealed, hot- or …

*The unit of modulus of elasticity shall be “106 psi”. *The moduli of elasticity of Monel 400 at different temperatures.